Les experts de Pass4Test ont fait sortir un nouveau guide d'étude de Certification Motorola Solutions MSC-122, avec ce guide d'étude, réussir ce test a devenu une chose pas difficile. Pass4Test vous permet à réussir 100% le test Motorola Solutions MSC-122 à la première fois. Les questions et réponses vont apparaître dans le test réel. Pass4Test peut vous donner une Q&A plus complète une fois que vous choisissez nous. D'ailleurs, la mise à jour gratuite pendant un an est aussi disponible pour vous.
Vous pouvez comparer un peu les Q&As dans les autres sites web que lesquelles de Pass4Test, c'est pas difficile à trouver que la Q&A Motorola Solutions MSC-122 est plus complète. Vous pouvez télécharger le démo gratuit à prendre un essai de la qualité de Pass4Test. La raison de la grande couverture des questions et la haute qualité des réponses vient de l'expérience riche et la connaissances professionnelles des experts de Pass4Test. La nouvelle Q&A de Motorola Solutions MSC-122 lancée par l'équipe de Pass4Test sont bien populaire par les candidats.
Pass4Test est un site de provider les chances à se former avant le test Certification IT. Il y a de différentes formations ciblées aux tous candidats. C'est plus facile à passer le test avec la formation de Pass4Test. Parmi les qui ont déjà réussi le test, la majorité a fait la préparation avec la Q&A de Pass4Test. Donc c'est pourquoi, Pass4Test a une bonne réputation dansn l'Industrie IT.
Code d'Examen: MSC-122
Nom d'Examen: Motorola Solutions (Deploy WLAN Solutions)
Questions et réponses: 113 Q&As
Le Certificat Motorola Solutions MSC-122 est un passport rêvé par beaucoup de professionnels IT. Le test Motorola Solutions MSC-122 est une bonne examination pour les connaissances et techniques professionnelles. Il demande beaucoup de travaux et efforts pour passer le test Motorola Solutions MSC-122. Pass4Test est le site qui peut vous aider à économiser le temps et l'effort pour réussir le test Motorola Solutions MSC-122 avec plus de possibilités. Si vous êtes intéressé par Pass4Test, vous pouvez télécharger la partie gratuite de Q&A Motorola Solutions MSC-122 pour prendre un essai.
Pass4Test peut offrir la facilité aux candidats qui préparent le test Motorola Solutions MSC-122. Nombreux de candidats choisissent le Pass4Test à préparer le test et réussir finalement à la première fois. Les experts de Pass4Test sont expérimentés et spécialistes. Ils profitent leurs expériences riches et connaissances professionnelles à rechercher la Q&A Motorola Solutions MSC-122 selon le résumé de test réel Motorola Solutions MSC-122. Vous pouvez réussir le test à la première fois sans aucune doute.
Aujourd'hui, il y a pleine de professionnels IT dans cette société. Ces professionnels sont bien populaires mais ils ont à être en face d'une grande compétition. Donc beaucoup de professionnels IT se prouver par les tests de Certification très difficile à réussir. Pass4Test est voilà pour offrir un raccourci au succès de test Certification.
MSC-122 Démo gratuit à télécharger: http://www.pass4test.fr/MSC-122.html
NO.1 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A
Motorola Solutions MSC-122 examen certification MSC-122
NO.2 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C
Motorola Solutions MSC-122 MSC-122 certification MSC-122 MSC-122
NO.3 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D
Motorola Solutions MSC-122 examen certification MSC-122 MSC-122
NO.4 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C
Motorola Solutions MSC-122 MSC-122 MSC-122 certification MSC-122
NO.5 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A
Motorola Solutions examen MSC-122 certification MSC-122
NO.6 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A
Motorola Solutions MSC-122 examen certification MSC-122 MSC-122 certification MSC-122
NO.7 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B
Motorola Solutions MSC-122 examen certification MSC-122
NO.8 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C
certification Motorola Solutions MSC-122 MSC-122 MSC-122 examen
NO.9 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D
Motorola Solutions examen MSC-122 MSC-122 MSC-122
NO.10 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A
Motorola Solutions examen MSC-122 examen MSC-122 examen MSC-122 MSC-122
NO.11 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B
Motorola Solutions MSC-122 MSC-122
NO.12 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D
Motorola Solutions MSC-122 examen MSC-122 MSC-122
NO.13 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B
Motorola Solutions examen MSC-122 MSC-122
NO.14 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C
certification Motorola Solutions MSC-122 MSC-122 certification MSC-122 MSC-122
NO.15 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A
Motorola Solutions MSC-122 MSC-122 certification MSC-122
Il y a beaucoup de gans ambitieux dansn l'Industrie IT. Pour monter à une autre hauteur dans la carrière, et être plus proche du pic de l'Industrie IT. On peut choisir le test Motorola Solutions MSC-122 à se preuver. Mais le taux du succès et bien bas. Participer le test Motorola Solutions MSC-122 est un choix intelligent. Dans l'Industrie IT de plus en plus intense, on doit trouver une façon à s'améliorer. Vous pouvez chercher plusieurs façons à vous aider pour réussir le test.
没有评论:
发表评论